CategoriesTips & Tricks

Mod. / enabling pitch controls

In this blog post, I’ll explain about how to enable pitch control function by simple modifications.

Pitch contol

The pitch control function was locked as default because the original concept of SnapBeat was simple sampler and I thought that the combination of recording sound quality setting (Lofi/Hifi) and the pitch controls makes it complicated. But you can unlock the function by some simple modifications.

How to enable pitch controls

You need to remove and add some components on the main PCB. Please prepare items below.

  • soldering iron
  • potentiometer B50k (50k ohm, B curve) x 3 (if you add pitch controls to the all eight channels, you need eight potentiometers)
  • hex wrench
Soldering iron
Potentiomenter
SnapBeat with hex wrenche.

Please prepare hex wrench.

Unscrewing the bottom case of SnapBeat, the simple lo-fi sampler

Unscrew the top two screws.
(no need to unscrew the bottom two screws) 

removing rubber feet of SnapBeat, the simple lo-fi sampler

Unscrewed the screws and rubber feet was removed.

Open top case of SnapBeat, the simple lo-fi sampler

Open top case.

modification points of pitch control

Remove the chip resisters on the main board. 

  • R76 : Pad 6
  • R91 : Pad 7
  • R92 : Pad 8
  • R82 : Pad 1
  • R81 : Pad 2
  • R80 : Pad 3
  • R83 : Pad 4
  • R78 : Pad 5
Pad1 – Pad 5 can be modified as same, but it’s a little bit harder because there isn’t enough space on the main board.
removed 0R resisters

Removed resisters.

Cut leg of potentiometer

Cut the first leg of potentiometers.

Soldered potentiometer for pitch control

Solder the two legs of potentiometers on the test points. 

Completed modification, pitch control

Pad 6, 7, 8 are modified.

Top case with holes

Drill three holes on the top case.

The 3D data of top case with holes will be available for download soon.

Screw the rubber feet and bottom and top case

Screw the rubber feet, top and bottom cases. 

Important notice

Operation of pitch control
Edit menu_1, SnapBeat, the simple lo-fi sampler

When the potentiometer is rotated clock wise, the playback speed of the sound becomes closer to its normal speed. On the contrary, when it’s rotated counter clock wise, the playback speed becomes slower. 

When you sample new sound, please not to forget to turn the potentiometer up to clock wise direction completely.
And please always use Hi-Fi mode sampling for the modified channels (Please don’t forget to record sounds with x0.5 speed).