How to assemble 3D cases of SnapBeat

Assembly instruction of 3D cases for SnapBeat.

Here is procedure of assembly 3D cases for SnapBeat.

Pre-soldered board of SnapBeat, the simple Lo-fi sampler

The LCD is attached onto PCB with 3D printed LCD holders.

photo from back of SnapBeat, the simple Lo-fi sampler

Place the back panel.

photo of SnapBeat PCB and bottom case
photo of SnapBeat PCB in the bottom case

Put pre-soldered board into the bottom case.

The bottom and top cases have enough strength with rib structure.

photo of SnapBeat PCB, bottom and top cases

Put the top case.

photo of screwing SnapBeat bottom case

Fix the bottom and top cases with screws at two corners.

photo of SnapBeat, top case front

Place the top front case.

Fix the bottom and top front cases with screws at two corners.

Put rubber feet at the four corners.

Assembly is completed.

photo of SnapBeat, gray and bone white color variations, the simple Lo-fi sampler

Now, SnapBeat has two color variations (left : gray, right : bone white)
On 7/29 today, only pre-soldered board is available on Tindie, but I’m going to list these two colors finished product with cases.

I sell on Tindie